Technics SA-DA10 Operating Instructions Manual page 34

1
RDS
2
TUNING
PTY SELECTOR
3
FM MODE
EON
34
RQT5518
3 2 1
TUNED STEREO RDS
SPEAKERS
A
TUNED STEREO RDS PTY
SPEAKERS
A
TUNED STEREO RDS PTY EON
SPEAKERS
A
RDS broadcasts
EON tuning
EON tuning is useful if the type of program you want to listen is
not currently being broadcast. It allows you to set the unit to
automatically change to a particular type of program when one
begins.
EON tuning only works if RDS data and EON signals are being
received.
EON tuning finds programs on stations that share EON signals.
1
Press [RDS].
2
Press [TUNING,
SELECTOR] to select the desired
program type.
Each time you press the selector, the PTY display will
change in sequence. (For PTY displays: a page 35.)
3
While the PTY display is flashing (approx. 10 seconds)
Press [FM MODE, EON].
MHz
"EON" will light up.
The current station remains tuned in until the selected type of
program begins. When the receiver finds the type of program you
selected, "EON" appears on the display and the message "OTHER
PROGRAM SERVICE" scrolls from right to left across the display.
The receiver automatically changes over at this time. If the type of
program you selected is currently broadcasting, the receiver will
immediately change to that station.
Note
EON tuning turns OFF if you operate the tuner (a pages 28–31),
change the input source, or turn the unit OFF.
When "NO EON" is displayed
The broadcast you are presently receiving does not provide EON
service.
To check the program type while on reception standby
Press [TUNING, ,
The program type last selected will be displayed for approximately
2 seconds. ("EON" will flash.)
Note
If you press [TUNING,
program type is being displayed, you will turn EON tuning OFF.
To cancel EON tuning
Press [FM MODE, EON].
"EON" will go out.
Only for the United Kingdom
, , PTY
, PTY SELECTOR].
, , PTY SELECTOR] again while the