Adjusting Speaker Output Level - Technics SA-DA10 Operating Instructions Manual

1
SA-DA10
1 2 3
VOLUME
4 5 6 +
–
7 8 9
DIRECT TUNING/
10/ENTER
DISC ENTER MUTING
0 -/--
DISC/DECK 1/2 MD SOUND MODE SFC
DVD
SLOW/
DELAY
SEARCH
TOP MENU MENU LEVEL
+
ENTER
–
DISPLAY RETURN
SUB TITLE AUDIO ANGLE TEST
– +
GROUP PAGE DIMMER
SPEAKERS
1
A B BI-WIRE
2 SA-DA10 SA-DA8
TEST
TEST
SA-DA10 SA-DA8
3
– +
VOLUME VOL
+
–
4
SA-DA10 SA-DA8
LEVEL
LEVEL
SA-DA10 SA-DA8
5
+
– +
–
BALANCE
SA-DA8
TOP MENU DVD
3
DISC/DECK
ENTER
1/2
DISPLAY MENU
STEREO SURROUND SFC TEST
– +
DELAY LEVEL
DIRECT TUNING/
1 2 3
DISC ENTER
4 5 6 10/–/– –
7 8 9 0
TV VOL TV/AV DVD 6CH
4
– +
DIMMER MUTING VOL
5
2
SPEAKERS
A
L C R RS LS SW
C RS LS SW
Preparatory steps

Adjusting speaker output level

Adjust speaker level so the output from all the speakers is the
same apparent level when sitting where you would normally enjoy
a source.
1
Press [A] or [BI-WIRE] to turn on
SPEAKERS.
A or BI-WIRE refer to the speaker terminals at the rear of
the unit.
You cannot adjust output level when SPEAKERS B is
selected.
2
by remote control only
Press [TEST] to output the test signal.
"TEST" appears on the display.
The signal is output from each speaker in order for about
2
two seconds each:
5 L: Front speaker (left)
C: Center speaker
4
R: Front speaker (right)
RS: Surround speaker (right)
LS: Surround speaker (left)
SW: Subwoofer
3
Speakers set as "NONE" or "NO" are skipped.
Note
DSP sound mode switches to SURROUND mode when the
test starts.
3
by remote control
Press [VOLUME (+ or –)] (SA-DA10) or
[VOL (– or +)] (SA-DA8) to set the
volume level normally used for
enjoying the source.
Note
Use [BALANCE] if the left right balance of the front
speakers is off.
4
by remote control only
Press [LEVEL] to select the speaker
channel to adjust.
The current level appears on the display.
Press again to change the speaker channel.
Speakers set as "NONE" or "NO" are skipped.
5
by remote control only
Press [+] or [–] to adjust the level to
the same apparent level as the front
speakers.
The four channels can be adjusted between –10 dB and
+10 dB, with zero being the current level of the front
speakers.
6
Repeat 4 and 5 for each speaker
channel.
To stop the test signal
Press [TEST].
Note
The test signal will not be output if VGCA is ON (a page 27).
19
RQT5518