Connecting The Ac Mains Lead And Other Information - Technics SA-DA10 Operating Instructions Manual

To connect an outdoor antenna
FM outdoor antenna
¡ Disconnect the FM indoor antenna.
¡ The antenna should be installed by a competent technician.
For the United Kingdom
OPTICAL
LOOP ANT
CD
HOLDER
DIGITAL
OPTICAL
DVD
OPTICAL
TV
PHONO
FM FRONT
R L
ANT
GND
75
SUBWOOFER CENTER
IN
For Australia and New Zealand
DVD/
DVD 6CH
SURROUND SURROUND
R L
L
LOOP
EXT
75
AM
R
TV
ANT
R IN L
coaxial cable
(not included)
AM outdoor antenna
¡ Run a piece of vinyl wire horizontally across a window or other
convenient location.
¡ Leave the loop antenna connected.
¡ Disconnect the antenna when the unit is not in use. Do not use
the antenna during an electrical storm.
OPTICAL
TV
PHONO
FM FRONT
R L
ANT
GND
75
SUBWOOFER CENTER
IN
DVD/
DVD 6CH
SURROUND SURROUND
R L
L
LOOP
EXT
AM
R
TV
ANT
R IN L

Connecting the AC mains lead and other information

L
LF
L
Cooling fan
R
The cooling fan operates at
high power output levels
R
only.
AC mains lead (included)
(FOR THE UNITED KINGDOM ONLY)
READ THE CAUTION FOR THE AC MAINS
LEAD ON PAGE 3 BEFORE CONNECTION.
FM outdoor antenna
(not included)
CD TAPE
REC PLAY
(OUT) (IN)
75 coaxial cable
L
(not included)
R
VCR 2 VCR 1
L
Antenna plug (included)
IN OUT IN
R
IN OUT IN
FM outdoor antenna
SUBWOOFER
OUT
IN
(not included)
TV
IN MONITOR OUT
300 feeder wire
(not included)
Antenna plug (included)
VCR 2 VCR 1
5–12 m
L
Vinyl-covered wire
IN OUT IN
R
(not included)
IN OUT IN
SUBWOOFER
OUT
IN
TV
IN MONITOR OUT
FRONT
R A L
IN IN MONITOR
OUT
AC IN
+
DVD VCR 1 TV
S-VIDEO
BI-WIRE HF
R L
–
SURROUND CENTER
L
+
L
–
The included AC mains lead is for
use with this unit only.
Do not use it with other equipment.
How to use the antenna plug (included)
For Australia and New Zealand
Two types of wire are most commonly used for connection from
the antenna: 300
For best resistance to outside interference, the use of 75
coaxial cable is suggested.
¡ ¡ ¡ ¡ ¡ To connect a 75
q Remove a piece of the outer vinyl insulator.
20 mm
w Carefully pull the tabs apart to remove the cover.
e Remove the lead wire and clamp it with the plastic bar.
r Install the coaxial cable.
Clamp the cable conductor, and wind it on so that it doesn't
contact anything else.
Press down with pliers.
t Attach the cover.
¡ ¡ ¡ ¡ ¡ To connect a 300
Loosen the screws, connect the wires, and tighten the screws
to secure the connection.
To household mains
socket
Note
parallel feeder wire or 75 coaxial cable.
coaxial cable
a
10 mm
Lead wire
Plastic bar
feeder wire
300 feeder wire
(not included)
AC mains lead
Connect this lead only after all other
cables and cords are connected.
Insertion of Connector
Even when the connector is perfectly
inserted, depending on the type of inlet
used, the front part of the connector
may jut out as shown in the drawing.
However there is no problem using the
unit.
Appliance inlet
Connector
Approx. 6 mm
13
RQT5518