8) Please wear gloves while handling this product to prevent injuries. 9) Product design and specifications may be revised to improve quality and performance. The diagrams used in this manual’s installation guide are based on the model Z7 Plus. Installation for the Z7 follows exactly the same installation procedure.
Z7 Plus / Z7 (2) External Features Front Side(left) (3) Top I/O Ports Headphones e-SATA Reset USB 2.0 Power Button HDD LED Power LED ※ The Z7 does not have an e-SATA port.
Side Panel (Right) Front Cover ② ⑦ 5.25” Bay Covers Side Panel (Left) ⑧ ③ Side Panel Fan 3.5” to 5.25” Bay Cover ⑨ ④ Controller HDD Rack ⑤ ※ The Z7 does not have a ④Side Panel Fan Controller.
Page 7
Z7 Plus / Z7 (5) Parts Main Unit Stand-Off × 9 A Bolts × 17 (6-32*6) [motherboard/PSU/PCI Slot Installation] B Bolts × 20 C Bolts × 6 (6-32*8) (PWH M3*5) [HDD Installation] [ODD, FDD, SSD Installation] Cable Ties × 5...
Z7 Plus / Z7 (3) Motherboard Installation Please refer to the diagrams below to determine Stand Off installation points before installing the motherboard. ATX Board m-ATX Board Stand-Off A Bolt...
Page 10
Z7 Plus / Z7 (4) Graphics Card Installation Click ▶ The PCI Slot can also be secured with Bolts. (5) 5.25” and 3.5” Drive Installation 1) Front Cover Removal PULL...
Page 11
Z7 Plus / Z7 2) ODD Installation 3) 3.5” Drive Installation ① HDD Rack Removal ② 3.5” HDD Installation B Bolt...
Page 12
Z7 Plus / Z7 4) Adaptor Tray Installation ① Adaptor Tray Removal ② Installation of Drive to Adaptor Tray A. For 3.5” FDD Installation C Bolt B. For 3.5” HDD Installation A Bolt...
Page 13
Z7 Plus / Z7 C. For 2.5” SSD Installation C Bolt 5) Front Cover Installation Please remove the Front Cover’s Bay Cover before installing to the case.
1) Power Button and LED Cable Connection Power Button Power Power LED HDD LED Motherboard 2) Top I/O Panel Cable Connection Top I/O Ports Audio HD Audio AC ’97 USB 2.0 Reset e-SATA Motherboard ※ e-SATA is only supported by Model Z7 Plus.
Page 15
Z7 Plus / Z7 ▶ For USB 2.0, e-SATA (Z7 Plus) and audio cables, please refer to the motherboard’s manual. ▶ In the event that the Power LED/HDD LED connector’s polarities(+/-) are reversed, the LED will not function properly. (7) Additional Fan Installation and Replacement (optional) 1) Side Panel Fan Installation (80/92/120/140㎜...
Page 16
(8) Side Panel Fan Control [Z7 Plus] The Z7 Plus comes equipped with a Fan Control on the left Side Panel. By connecting the 4-Pin Power Connector and the 3-Pin Fan Connector to the Fan, the Fan Speed can be controlled using the Fan Speed Controller.