4
6
8
6
5
7
Installation
Hot control
handle
Hot inlet
Rubber
washer
Nut
Before installing your new mixer, flush through the pipework to ensure removal of
debris, turn off the water supply.
Ensure that the seal is in place underneath of the body.
Position the mixer on the bath. From the underside of the bath fit the rubber
washers and nuts. Tighten the nuts to clamp the mixer to the bath.
CAUTION: Do not over tighten the nuts as this may damage the bath.
Connect the water supply to the inlet pipes. The hot water should be connected to
the left hand pipe and cold to the right.
Place a rubber washer into the nut end of the hose and attach it to the mixer outlet.
Nut
Cold control
Rubber
handle
washer
Seal
Cold inlet
Rubber
washer
Nut
7