Clutch Lever Adjustment; Idle Speed Adjustment; Throttle Cable Slack Adjustmen - SHERCO 50 SE Owner's Manual

Settings
C
n THROTTLE CABLE SLACK ADJUSTMENT
In the case where the throttle cable slack is
greater than 3 mm, measured from the edge
of the handle, it is necessary to perform an
adjustment using the adjuster on the
carburetor B.
A
B
A

CLUTCH LEVER ADJUSTMENT

To adjust the clutch lever A lift the rubber
cover and use the adjusting fitting B to obtain
a free play of 5mm.

IDLE SPEED ADJUSTMENT

To perform this operation correctly it is
recommended that it be performed on a hot
engine. Using an electronic rev counter that
is connected to the spark plug cable.
Utilize a screwdriver on the adjuster screw A
and set the idle to 1900 rpm.
75