Radio; Selecting Tuner Band; Tuning To A Station; Using Presets - THOMSON MS2200 User Manual

MS2200 EN 11/17/03

Radio

Selecting Tuner Band

EN
1. Press SOURCE to select TUNER.
2. Press BAND to select radio band.
Tips:
Your audio system has 32 preset stations.

Tuning to a Station

Press SKIP BACKWARD
to select frequencies.
87.50 MH

Using Presets

The tuner can be in either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press TUNE•PRESET to toggle TUNE and
PRESET mode.
• Press SKIP BACKWARD
FORWARD
UP or DOWN on the remote control to access
the previous or next preset station. The display
first shows the preset program number and
after a few seconds, the frequency will be
displayed. (FMPR:01 is FM preset 1)
PR:01
9
1:59 PM Page 14
or SKIP FORWARD
z
or SKIP
on the main system or PRESET
Auto Preset Programming
(FM only)
Press and hold the BAND button for 2 seconds to
scan stations in FM band. The stations will then
be stored as preset channels. A maximum of 32
stations can be stored. Beware of your preset
channels being erased accidentally because the
scanning and storing process is automatic upon
pressing the button. You can stop the automatic
scan by pressing any button, but the erased sta-
tions cannot be recovered.

Manually Setting Presets

1. Press the TUNE•PRESET button to enter TUNE
mode.
2. Press SKIP BACKWARD
FORWARD to access the desired
frequency.
3. Press the PROG•SET button once.
4. The most recently accessed program location
will be displayed.
5. If a different program location is preferred,
press SKIP BACKWARD
FORWARD to move to the desired preset
number (1-32).
6. Press PROG•SET to store the selected
frequency at that preset.

Suppressing Stereo Signal

Press FM ST. to toggle between FM mono and
stereo for stereo FM stations. (Remote Only)
or SKIP
or SKIP