CS-2510TES
250Ts, 250TCs
8-2 Cleaning cooling air passages
B
E
ENGINE
A
D
1. Remove starter assembly (A) and fan cover (B).
2. Inspect starter assembly (A) and fan cover
(B) for blockage with dirt and/or saw dust. Clean
them with wooden or plastic stick or brush or com-
pressed air as required.
WARNING
Always wear eye protection when using
compressed air for cleaning. Otherwise,
eye damage can occur from fl ying particles.
3. Inspect cylinder cooling fins (C) for blockage
with dirt and/or saw dust (D). Clean them with
wooden or plastic stick or compressed air as re-
quired.
C
D
NOTE: Remove ignition coil (E) if cylinder fi ns are
hard to clean.
57
DANGER