Replacing Rear Handle And Springs - Echo CS-2510TES Service Manual

CS-2510TES
250Ts, 250TCs

9-3 Replacing rear handle and springs

{Disassembling}
1. Remove starter assembly, sprocket guard, muffler cover, chain catcher, sprocket guard plate, and
brake lever (Refer to "6-1 Replacing brake lever and torsion spring")
2. Remove rear handle lid and throttle control parts (Refer to "9-1 Replacing throttle control parts").
3. Remove front handle and spring (Refer to "9-2 Replacing front handle and spring").
4. Remove air cleaner cover and air fi lter(Refer to "4-1 Inspecting air fi lter" ).
5. Remove carburetor (Refer to "4-8 Testing carburetor"), two plugs (A), collor (B) and (C) inserted intake
bellows.
6. Remove purge bulb and fuel line assembled rear handle (Refer to "4-5 Replacing purge bulb" and "4-6
Replacing fuel line and fuel return line").
G
C
A
H
J
E2
H
HANDLE AND CONTROL SYSTEM
E2
B
F
K
E1
G
g1
J
7. Remove bolt (D) and spring (E1).
E1
8. Remove bolt (F)
D
9. Remove rear handle (G) and spring (E2) from
unit.
10. Remove bolt (H) and spring (J) from rear han-
dle (G)
11. Check rear handle and springs and replace de-
fective part(s) with new one as required.
{Assembling}
12. Install spring (E2) to engine cover (K) as
shown.
D
13. Install spring (E1) as shown and tighten bolt (D).
NOTE : Spring (E1) and (E2) are the same.
14. Install spring (J) to rear handle (G) and lightly
tighten bolt (H).
NOTE : Make sure spring (J) is installed parallel to
line (g1) of rear handle (G).
71