Ford Thunderbird Manual page 164

03-01 8-60
IN-VEHICLE SERVICE (Continued)
Check flywheel runout, if necessary. Refer to
2.
Section 03-00.
3. Install transmission. Refer to Section 07-Q 1 .
Crankshaft Rear Oil Seal
NOTE: A one-piece crankshaft rear oil seal (670 1 ) is
used for replacement on all engines. If replacement is
necessary, this type of crankshaft rear oil seal MUST
BE used. The complete crankshaft rear oil seal can be
replaced without removing the crankshaft (6303).
SPECIAL SERVICE
Description
Slide Hammer
Rear Crankshaft Slinger Remover
Rear Crankshaft Seal Remover
Rear Crankshaft Seal Adapter
Rear Crankshaft Seal Replacer
Rear Crankshaft Slinger Replacer
Removal
1 . Remove transmission from vehicle. Refer to
Section 07-0 1 .
2 . Remove flywheel (6375).
3. Remove crankshaft oil slinger (63 1 0) using Rear
Crankshaft Slinger Remover T95P-670 1-AH and
Slide Hammer T50T- 1QO-A.
4. Remove crankshaft rear oil seal using Rear
Crankshaft Seal Remover T95P-6701 -EH and
Slide Hammer T50T- 1 0Q-A.
5. If required, remove crankshaft rear oil seal
retainer (6335).
Installation
1 . Clean and inspect crankshaft rear oil seal retainer
and retainer-to-cylinder block mating surfaces.
2. NOTE: Prior to applying sealer, clean sealing
surfaces with Metal Surface Cleaner
F4AZ- 1 9A536-RA or equivalent meeting Ford
specification WSE-M5B392-A, to remove all
residues that may interfere with the sealer's
ability to adhere.
NOTE: Crankshaft rear oil seal retainer must be
installed and bolts tightened to specification
within five minutes of sealer application.
Apply a 2.0 mm (0.08 inch) continuous bead of
Anaerobic Gasket Compound Sealer or
equivalent meeting Ford specification
WSK-M2G348-A9 to cylinder blocks (60 1 0) as
shown.
Engine, 4.6L (2V)
TOOL(S) REQUIRED
Tool Number
T50T- 1 00-A
T95P-670 1 -AH
T95P-670 1 -EH
T95P-6701-DH
T95P-670 1 -BH
T95P-6701-CH
Install crankshaft rear oil seal retainer and tighten
3.
bolts in sequence shown to 8- 1 2
I b-in).
4. Install new crankshaft rear oil seal using Rear
Main Seal Replacer T95P-670 1-BH and Rear
Crank Seal Replacer Adapters T95P-6701 -DH.
REAR CRANKSHAFT SEAL ADAPTER
T95P-6701-DH
REAR CRANKSHAFT SEAL REPLACER
T95P-6701-BH
03-018-60
BLOCK
CYUNDER
6010
ANAEROBIC GASKET
COMPOUND SEALER
MEETING FORD
SPECIFICA TION
WSK-M2G348-A9
AA0629-A
(7 1-106
N·m
CRANKSHAFT
REAR MAIN
SEAL
6701
AA0243-A
1997 Thunderbird, Cougar July 1996