Table of Contents
Advertisement
>>
Using a PC
<<
Control of the Monitor (Continue)
Command format
Eight ASCII codes +CR
Command 4-digits: Command. The text of four characters.
Parameter 4-digits: Parameter 0–9, x, blank, ?
Parameter
Input the parameter values, aligning left, and fill with blank(s) for the remainder. (Be sure that 4
values are input for the parameter.)
When the input parameter is not within an adjustable range, "ERR" returns. (Refer to "Response
code format".)
Any numerical value can replace the "x" on the table.
Response code format
Normal response
Problem response
(communication error or incorrect command)
Command table
Commands not indicated here are not guaranteed to operate.
CONTROL ITEM
COMMAND
POWER ON
R
COMMAND SETTING
POWER SETTING
P
INPUT
TOGGLE I
SELECTION
*1 For RS-232C only.
You can use "Wake On LAN (Magic Packet)" to turn on the power via LAN.
It is not possible to turn on the monitor with the IP Control command.
NOTE
If an underbar (_) appears in the parameter column, enter a space.
If an asterisk (*) appears, enter a value in the range indicated in brackets under CONTROL
CONTENTS.
Any numerical value can replace the "x" on the table.
ENG 7-4
PARAMETER
CONTROL CONTENTS
S
P
W
0
_
_
_
Off
1
_
_
_
On [RS-232C]
2
_
_
_
On [IP]
O
W
R
0
_
_
_
Power Off
1
_
_
_
Power On
T
G
D
x
_
_
_
(Toggle)
The Power On
command
rejected.
The Power On
command
accepted.
The Power On
command
accepted.
It shifts to
standby.
Power On*1
It input-switches
by the toggle. (It
is the same as
an input change
key)
Hide quick links:
Advertisement
Table of Contents
