WERTHEIM SE2000 User Manual page 10

INSTRUCTIONS FOR USE (cont'd)
deactivated. For this reason, have a cloth laid out that you can place the
shampooer on after use.
4. Push the shampooer forward along the carpet border and depress
the button for emitting the cleaning solution. This will apply and brush
the cleaning solution into the carpet. In the process, walk next to the
shampooer. Do not step on the wet carpet! Once you have arrived at the
other end of the carpet, release the button.
5. Repeat above steps The dirty water will be vacuumed up.
6. Start the next strip slightly overlapping the cleaned carpet strip. Work with
even forward and backward movements up to the other edge of the
carpet. In the event of stubborn dirt, go over a strip of the carpet several
times if necessary.
7. When the dirty water tank is filled to the max fill line, it must be emptied. If
you would like to empty the dirty water tank, fill up the fresh water tank or
finished cleaning, switch off the appliance by pressing the on/off switch,
lay it on the prepared cloth, and bring the handle to the upright position.
Note: Do not store or transport the appliance when liquid is still in the tanks.
8. Remove the power plug from the power socket.
8
1. Press down the shampooer, unlocking the
pedal and set the handle to a comfortable
position.
2. Using your foot, press the on/off switch to turn
on the appliance.
3. Run the shampooer to a corner of the carpet.