Table of Contents
Advertisement
2_DTH8555 X_en.qxd
Remote control - Code A-B
With certain devices (combined TV/DVD or other DVD player) it may happen that your DVD
recorder controls the DVD player of the other device. In this case you can adjust your remote
control and the DVD recorder on another code known as code B.
Remote control setting on code B
No. to key in
3000
Code A
3001
Code B
1.
Press and hold the
2.
With the number keys, press
3.
Release the
DVD recorder setting on code B
1.
Switch on your DVD recorder.
2. Check that there is no disc in the disc tray.
3.
Simultaneously press the
release them when your DVD recorder displays
4.
Try to control your DVD recorder with the remote control.
Note: in the event of a problem, redo the setting of both components: the remote control and your DVD
recorder.
Technical data
Power requirements 220 to 240 V - 50/60 Hz
Power consumption:
• Operating
• Standby
• Standby, ECO mode = 4 W
Hard disc capacity:
Functioning conditions +5°C to + 35°C surrounding humidity: 80 % maximum
Playback system Laser diodes - Wave length: 655 / 780 nm, Laser power CLASSE 2
Reception norms LL' - BG - I - DKK'
Number of storable channels 99
Remote control Infrared 33 Khz - Batteries 2 x 1.5 V (AAA)
Nominal Specification - THOMSON reserves the right to change the specifications without notice. The
characteristics and aspect of the product may be changed without prior notification. The colour and aspect of
the product may differ from that represented in this manual.
18/08/05
10:15
Page 75
Note: the remote control of your DVD recorder is set to code A
On display panel
(3000). To set it to code B (3001) follow the procedure
DVD A
DVD B
described below.
key.
DVD
3
,
0
,
0
,
1
.
key.
DVD
PLAY/PAUSE
= 36 W
= 5 W
160 Gb
Further information
,
keys at the front of your DVD recorder and
AV
DVD B
.
75
DTH 8555 X / SOFT A4ZJEU_S2-09 / EN - lj - ED / aws - rst / 08-2005
EN
EN
Advertisement
Table of Contents
