Table of Contents
Advertisement
Interactive Registration
The interactive registration feature allows the installer to register the 7835C through a series of keyboard
commands on the 7720P installation tool. This method of registration lets the installer monitor the
registration process.
Registration
MSG1 Sent
Registration
MSG2 Sent
Registration
MSG3 Sent
Registration
Waiting for ACK
Registration
Successful!
Possible Errors
MIN Exists
Registration
Timed Out!
Reg Reject
Bad ID! PS
Account Exists
Sub Y/N
Replacement Radios
Once the installation is complete the installer should select the
[↑] command on the 7720P.
Three messages are sent, then the unit waits for acknowledgment.
If this is a new installation, and the City, CS, and Cust# have
been correctly entered, the 7835C will be registered and this
message will be displayed. At this point the 7835C is in full
service and available for alarm reporting to the central station.
This prompt may appear only if this is a test registration and
indicates that a different account number is already associated
with this MIN in the AlarmNet database.
If no response to the registration request is received from
AlarmNet, this message will be displayed.
If the City, CS, and Cust# were not correctly entered, this
message will be displayed.
If this message is displayed with a "P" primary ID, and or an "S"
secondary ID, it indicates that the ID information was either
entered in error, or the central station failed to pre-authorize
programmed ID numbers with AlarmNet customer service.
This prompt is displayed if this is a repair/replacement, or an error
was made in programming the 7835C for an existing account.
If this is a test registration, the opportunity to substitute the radio
will not be offered.
Do You Have A
PIN # Y/N
– 21 –
At this point the installer should have
called in for a 4-digit alpha numeric PIN
# that must be obtained by having an
authorized person call the AlarmNet
Technical Assistance Center (TAC).
Answering "Y" will continue the
registration process. Answering "N" will
abort the process. If "Y" was selected
then the next prompt will be displayed.
Advertisement
Table of Contents
