Section 5. Registration - ADEMCO AlarmNet 7835C Installation Instructions Manual

6H.WLRQ 5HJLVWUDWLRQ
Test Registration
Prior to registering the radio, a test registration can be sent. The test registration is used to confirm the
programming of the radio and the routing across the AlarmNet C network without actually registering the
radio. This feature requires a 7720P.
To initiate a test registration, first complete Quick Start programming. Options 2, 3, and 4 must be
programmed. After this, press shift-"T" on a connected 7720P. Test registration progress messages will be
displayed on the 7720P as described in the Interactive Registration paragraph below. When a test
registration has been completed, the radio will be reported to the central station as 5555 5555 9. This
indicates that the radio is programmed and routed correctly, but is not registered. If test registration fails, a
message on the 7720P will indicate the failure.
Registering the Radio
Once you have initialized and programmed the 7835C, you must register it with AlarmNet Control. An
unregistered 7835C is indicated on the radio status LEDs as: solid green, blinking yellow, and unlit red.
The registration process consists of transmitting 3 messages in succession and receiving a registration
validation from AlarmNet Control. It can take several minutes to complete.
Initiate the registration sequence by either clicking the tamper switch 3 times or by pressing shift and the up
arrow [↑] on the 7720P. If you are using a 7720P, skip to the Interactive Registration section.
You can monitor the registration process on the RSSI display as follows: yellow LED will be blinking and
the green LED at the extreme right of the display will blink. When this green LED lights solid, the next
green LED to the left begins to blink. When this LED lights solid, the next green LED begins to blink, and
so on, until all 4 green LEDs are lit solid.
Once you have successfully completed the registration, the radio will enter normal operating mode; the
green radio status LED extinguishes, the yellow radio status LED continues normal blinking, and the RSSI
display indicates received signal strength.
If registration is not validated within 90 seconds, the 7835C will time out and all 5 RSSI LEDs will blink in
unison for 30 seconds. If repeated registration attempts time out, select a new installation site.
If the 7835C has been programmed with an invalid ID, city, or central station number, the registration will
be rejected. The right green LED will blink alternately with the remaining 4 RSSI LEDs.
M S G 1 M S G 2
S E N T S E N T
G
Y
R
G G G G
Y
Y G G G G
"click"
"click"
"click"
M S G 3 W A I T
S E N T A C K
REGISTRATION
registration
Y G G G G
progress
Y G G G G
– 20 –
on
off blink rapid
blink
LED Key