Panduit FMT1J Installation Instructions

© Panduit Corp. 2014
FMT1J
FMT2J
Contents:
1 - Enclosure
4 - Strain Relief
2 - Brackets
2 - Short Grommets (FMT1J)
2 - Long Grommets (FMT2J)
CAUTION:
Fiber optic cable is sensitive to excessive pulling, bending and crushing forces. Consult the manufacturer's cable specification sheet for
the specific cable in use.
Follow TIA/EIA 568-A, 569, 606, and 607 installation guidelines where applicable.
DANGER: UNMATED CONNECTORS MAY EMIT INVISIBLE LASER RADIATION. DO NOT LOOK DIRECTLY INTO THE END OF THE
CONNECTOR, DO NOT INSPECT WITH MAGNIFYING DEVICES. MAINTAIN CAP ON UNMATED CONNECTORS.
ASSEMBLY
(FMT1J shown)
M5 black oxide nut
and flat washer
1RU grommet
Fiber Caution Label
Fiber laser beam
warning label
Bracket
Adapter panel
(FAP3HWBUDSC shown)
Wire retainer
M5 screw
with flat washer
M6 screw
#12-24 screw
Cable Tie
For Technical Support: www.panduit.com/resources/install_maintain.asp
Fiber Optic Connector Enclosures for Japan
Part Numbers: FMT1J, FMT1J4HWBUDSC, FMT1J6HWBUDSC, FMT1J8HWBUDSC,
FMT1J12HWBUDSC, FMT2J, FMT2J24HWBUDSC, FMT2J16HWBUDSC,
FMT2J18HWBUDSC, FMT2J20HWBUDSC
INSTALLATION INSTRUCTIONS
FMT1J4HWBUDSC
FMT2J16HWBUDSC
4 - Grounding Lug
4 - M6 Screws
4 - M5 Screws with Flat Washers
4 - M5 Black Oxide Nut & Flat Washer
8- PLT2S Cable Tie
FMT1J6HWBUDSC
FMT2J18HWBUDSC
1 - Splice Tray without Cover
(FMT1J12HWBUDSC)
1 - Fiber Caution Label
1 - Fiber Laser Beam Warning Label
5 - Wire Retainers
Page 1 of 4
FMT1J8HWBUDSC
FMT2J20HWBUDSC
4 - #12-24 Screws
1- Splice Tray with Cover
(FMT1J, FMT1J6HWBUDSC
and FMT1J12HWBUDSC)
Cover
Grounding lug
FS066
FMT1J12HWBUDSC
FMT2J24HWBUDSC
Splice tray
cover
Splice tray
Strain relief
Enclosure