Electrics Box 39 En; Service Intervals; Operating Readings - CIAT MAGISTER Series Instruction Manual

13-6 Electrics box
Retighten the connections twice a year.
Visually inspect the components, wires and cables.

14 - SERVICE INTERVALS

DEVICE
Filters
Cooling coil
Electric heater (option)
Humidifier (option)*
Fan(s)
Electrics box
Hydraulic circuit
Water leak detection
sensor and relay
Filter pressure switch
Thermostat and fire
control relay
Valve
Pressure gauge
* If a water softener or water treatment system is used, the water hardness should not be less than 40% of the initial hardness
and should never be less than 15°f.

15 - OPERATING READINGS

DATE/TIME
Rated voltage (V)
Voltage at terminals (V)
Fan motor absorbed current (A)
Mechanical check: pipes, screws, etc.
Electrical connection tightness check
Clean the coil
Control check
Filter check
Leak test
This document is not legally binding. As part of its policy for continual product improvement, CIAT reserves the right to make
AT COMMISSIONING
- Check the connections
- Check the connections
- Check correct operation
- Check the connections
- Check correct operation
- Check correct operation and the
adjustment of the setpoint
- Check correct operation
- Check the circuit for correct operation
and tightness
- Check the pressure and top up
or fill the circuit as necessary
any technical modification it considers necessary without prior notice.
2-3 MONTHS
- Replace
- Clean
- Clean
- Check the condition of the tank;
replace if necessary
- Check correct operation
- Check correct operation and setpoint
adjustment
- Check correct operation
EN - 39
12 MONTHS
- Replace
- Check and clean the condensate drains
- Retighten the electrical connections
- Check the components
- Retighten the electrical connections
- Check the components
- Check the condensate drains
- Make sure that steam is evenly distributed
- Retighten the electrical connections
- Retighten the electrical connections
- Check the components
- Check the insulation
- Check correct operation
- Check correct operation and setpoint
adjustment
- Check correct operation
- Check correct operation
N 14.54 B
EN