Installation; Right Place For Installation; Attaching The Plastic Wedges - Beko GNE60520DX User Manual

3

Installation

3.1. Right place for
installation
Contact the authorised Service for
the product's installation. To ready
the product for installation, see the
information in the user guide and make
sure the electric and water utilities are
as required. If not, call an electrician
and plumber to arrange the utilities as
necessary.
WARNING:
B
assumes no responsibility for
any damage caused by the work
carried out by Unauthorised
persons.
WARNING:
B
cable must be unplugged during
installation. Failure to do so may
result in death or serious injuries!
WARNING
A narrow for the product to pass,
remove the door and turn the
product sideways; if this does not
work, contact the Unauthorised
service.
• Place the product on a flat surface to
avoid vibration.
• Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
• Do not expose the product to
direct sunlight or keep in damp
environments.
Refrigerator / User Manual
The manufacturer
The product's power
: If the door span is too
• The product requires adequate air
circulation to function efficiently. If
the product will be placed in an alcove,
remember to leave at least 5 cm
distance between the product and the
ceiling and the walls.
• Do not install the product in
environments with temperatures
below -5°C.
3.2. Attaching the
plastic wedges
Use the plastic wedges provided with
the product to provide sufficient space
for air circulation between the product
and the wall.
1. To attach the wedges, remove the
screws on the product and use the
screws provided with the wedges.
2. Attach 2 plastic wedges on the
ventilation cover as shown in the
figure.
7 / 40 EN