Sunbeam SB20 Operating Instructions Manual page 8

•
Curtains and draperies can be steamed while still hanging
(Figure 13).
•
Heavier fabrics may require repeated steaming. To remove
stubborn wrinkles, the Fabric Brush may be used.
Important:
Pulling on the garment with too much force may
cause the unit to tip. Handle gently.
USING THE STEAMER'S FABRIC BRUSH:
The garment steamer comes with a Fabric
Brush, which sweeps away lint, unwanted
threads, etc.
To use the Fabric Brush, turn off steamer and
wait until the steam nozzle emits no steam.
Press the brush firmly into the two pegs at
corners of the steam nozzle.
MAINTAINING YOUR STEAMER:
1.
Unplug steamer. Allow the steamer to cool for at least 30
minutes.
2.
Remove the Hose and shorten the Telescopic Pole.
3.
Remove and drain the Water Tank. Rinse the water tank with
fresh water, and drain completely. Place the tank back onto
the Water Reservoir.
4.
Drain the steamer by removing the Drain Plug and allowing
the water to empty.
5.
Flush the unit by filling the Water Reservoir and the hose
connector with fresh water and draining completely. Replace
the Drain Plug.
6.
Wrap the Hose around the Telescopic Pole one time. Place
the Steam Nozzle on the steam nozzle holder. Store in a cool,
dry place.