Pressing With Steam - Sunbeam SB20 Operating Instructions Manual

around the angle of 40
degrees, and then insert it
into the hole of Clothes Rack
(A). (Figure 7)
3.
Press the hook (D) vertically
and tighten it. (Figure 8)
4.
Pull the arm of the Folding
Rack (E) out until two poles
(F) are in alignment. (Figure
9-10)
5.
Push the fixed pipe (G) onto
the pole (F) by aligning the
salient dots on the hole of fixed pipe (G) and the pole (F).
(Figure 11)
CAUTION:
Do not install the accessories while steam emitting from the
Steam Nozzle to avoid burns.
•
To steam a garment, either place it on a clean,
rust-free clothes hanger and clip onto the
Clothes Hanger Hook, or hang the garment
directly on supplied Hanger.
•
Hold the handle in a vertical position with the
Steam Nozzle at the bottom of the garment.
Steam will rise along the inside and outside
of the fabric, removing wrinkles. Slowly slide
the nozzle upward and downward along the
garment (Figure 12). Do not allow kinks to form
in the hose at any time. Repeat as necessary
until garment is wrinkle-free.

PRESSING WITH STEAM:

Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13