Chain Dialing - Sanyo CLT-9902 Instruction Manual

All manuals and user guides at all-guides.com
CLT9902 #4 (SANYO) 8/11/00
Dialing a Stored Number
To dial a phone number stored in memory, press
TALK/END, then press MEMORY and the memory
location (0–9) number. Your phone will dial the stored
number.
If you select a memory location that
does not have a stored number, the
handset will beep rapidly and the phone
will not dial.
Mute
You can turn off the handset microphone while you
are on the phone, so that your calling party cannot
hear you.
1
Press MUTE during a telephone call.
The microphone is turned off.
2
To cancel mute, press MUTE or TALK/END.

Chain Dialing

You can store a special access code, a number to
access banking transaction, for example, and then
use chain-dialing to facilitate your operation.
1
Store the access code into one of the memory
location (0–9).
2
Dial the main number.
3
Press MEMORY and the memory location of the
access code at the appropriate time.
Erasing a Stored Number
1
Remove the handset from the base.
2
Press MEMORY twice.
3
Press the memory location number (0–9) you
want to clear. You hear a long beep confirming
that you have erased the number.
Replacing a Stored Number
Your phone has 10 memory locations, represented by
the numbers 0–9 on the keypad. If you store a phone
number in one of these locations and attempt to
store a different number in the same location later,
the new number will replace the previous one.
4:14 PM Page 8
Selecting a Different Channel
If you encounter interference while using your phone,
you can manually change the channel for clearer
communication. Interference can come from
appliances or other phones in your home.
The SCAN button on the handset allows you to
choose from 40 factory-set channels. During the
course of a conversation, if you hear static or noise
which makes it difficult to hear, press SCAN. The
TALK/BATT LOW indicator flashes while the phone is
changing to another channel.
This function works only when the phone is in use.
Using the Flash Button
Use FLASH for accessing special services* offered by
your telephone company such as Call Waiting. If you
receive a call during your conversation, you hear a
beep. Press the FLASH button on the handset to
answer the new call. Press FLASH again to return to
the previous call.
*Subscription required.
Using the Page/Find Feature
The Page/Find feature sends a signal from the base
to the handset causing it to beep. This is useful for
locating the handset when it is away from the base.
To use this feature, press PAGE/FIND on the base.
The handset beeps for 60 seconds. (Press and hold
the PAGE/FIND button to get a continuous beep.)
On the handset, press any key except TALK/END to
end the page. If you want to end the page and make
a call, press TALK/END.
Press TALK/END again if you do not wish to make a
call.
Travelling Out of Range
When you begin to move too far from the base, you
will first hear a clicking sound. As you travel further
out of range, the voice transmission will begin to
break up.
If you pass the range limits of the base, your call will
terminate.
E7
The paging feature does not work when
the phone is in use.