Setting Up Your Phone; Adjusting Ringer/Volume Controls - Sanyo CLT-9902 Instruction Manual

900-mhz compander plus noise reduction
Hide thumbs Also See for CLT-9902:
Table of Contents

Advertisement

All manuals and user guides at all-guides.com
CLT9902 #4 (SANYO)
8/11/00
Handset retainer
8
On the base unit, pull the handset retainer out of
the slot. Rotate it clockwise 180 degrees.
9
Flip it over. Slide it back into the slot so that the lip
of the retainer is up and the
retainer holds the handset in place.
When the beltclip is attached onto the
handset, you can hang the handset on
the wall-mounted base with the
keypad facing inside only.
Raising the Antenna
Before using your phone, be sure to raise the base
antenna fully to the vertical position.

Adjusting Ringer/Volume Controls

M Ringer Tone and Volume
1
While the phone is not in use, press RINGER.
2
The phone has two ringer tones, each with two
volume levels. Press RINGER again until you hear
the ringer tone and volume level you want.
4:14 PM
Page 6
M Direct wall plate mounting
If you do not have a standard wall plate, you can
mount your phone directly to the wall. Before doing
this, consider the following:
• Avoid electrical cables, pipes or other items behind
the mounting location, that could cause a hazard
when inserting screws into the wall.
• Try to mount your phone within 10 –15 feet of a
working phone jack to avoid excessive cord
lengths.
• Make sure the wall material is capable of
supporting the weight of the base and handset.
• Use #10 screws with anchoring devices suitable
for the wall material where the base unit will be
placed.
TOP
points down. The
3/16 in.
3-15/16 in.
(100 mm)

Setting Up Your Phone

M Setting the Handset Earpiece Volume
1
While you are on a call, press VOLUME
or
.
2
The phone has three receiver volume levels,
Normal, High, and Loud. Press VOLUME
repeatedly until you hear the volume level
you want.
When you hang up, the phone keeps the last
volume setting selected.
E5
1
Insert two mounting
screws with a minimum
(4.8 mm)
length of 1-3/8 inches
(35.5 mm) into the wall,
3-15/16 inches (100 mm)
apart. Allow about 3/16 of
an inch (4.8 mm) between
the wall and screwheads
for mounting the phone.
2
Refer to steps 1 through 9
on page 4 and 5 to mount
the telephone.
or

Advertisement

Table of Contents
loading

This manual is also suitable for:

Clt-9901

Table of Contents