Table of Contents
Advertisement
All manuals and user guides at all-guides.com
CLT2410 (SANYO) A5 2nd
Dialing a Stored Number
To dial a phone number stored in memory, press
TALK/END, then press MEMORY and the memory
location (0–9) number. Your phone will dial the
stored number.
If you select a memory location that
does not have a stored number, the
handset will beep rapidly and the phone
will not dial.
Mute
You can turn off the handset microphone while you
are on the phone so that your calling party cannot
hear you.
1
Press MUTE during a telephone call.
The microphone is turned off.
2
To cancel mute, press MUTE or TALK/END.
Chain Dialing
You can store a special access code, a number to
access banking transactions, for example, and then
use chain-dialing to facilitate your operation.
1
Store the access code into one of the memory
locations (0–9).
2
Dial the main number.
3
Press MEMORY and the memory location of
the access code at the appropriate time.
Erasing a Stored Number
1
Remove the handset from the base.
2
Press MEMORY twice.
3
Press the memory location number (0–9) you
want to clear. You hear a long beep confirming
that you have erased the number.
Replacing a Stored Number
Your phone has 10 memory locations, represented
by the numbers 0–9 on the keypad. If you store a
phone number in one of these locations and
attempt to store a different number in the same
location later, the new number will replace the pre-
vious one.
7/18/00
6:41 PM
Page 8
Selecting a Different Channel
If you encounter interference while using your
phone, you can manually change the channel for
clearer communication by pressing the SCAN but-
ton. This function works only when the phone is in
use.
Interference can come from appliances or other
phones in your home.
The SCAN button on the handset allows you to
choose from 30 factory-set channels. During the
course of a conversation, if you hear static or noise
which makes it difficult to hear, press SCAN. The
TALK/BATT LOW indicator flashes, indicating the
phone is changing to another channel.
Using the Flash Button
Use FLASH for accessing special services* offered
by your local telephone company, such as Call
Waiting. If you receive a call during your conversa-
tion, press the FLASH button on the handset. Press
FLASH again to return to the previous call.
*Subscription required.
Using the Page/Find Feature
The Page/Find feature sends a signal from the base
to the handset causing it to beep. This is useful for
locating the handset when it is away from the base.
To use this feature, press PAGE/FIND on the base
for less than 2 seconds. The handset beeps for 5
seconds. Press PAGE/FIND more than 2 seconds to
within a minute, the handset beeps for a minute.
(Press and hold the PAGE/FIND button for more
than 1 minute to get a continuous beep.)
On the handset, press any key except TALK/END to
end the page. If you want to end the page and
make a call, press TALK/END.
Press TALK/END again if you do not wish to make a
call.
Travelling Out of Range
When you begin to move too far from the base, you
will first hear a clicking sound. As you travel further
out of range, the voice transmission will begin to
break up.
If you pass the range limits of the base, your call will
terminate.
E7
The paging feature does not work
when the phone is in use.
Advertisement
Table of Contents
