Electrolux EIV9467 User Manual page 18

18 www.electrolux.com
Problem
You cannot select the
maximum heat setting for
one of the cooking zones.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
The hob deactivates.
Residual heat indicator
does not come on.
Hob²Hood does not work.
The sensor fields become
hot.
There is no sound when
you touch the panel sensor
fields.
comes on.
and a number come on. There is an error in the
You can hear a constant
beep noise.
Possible cause
The other zones consume
the maximum available
power.
Your hob works properly.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
You covered the control
panel.
The cookware is too large
or you put it too near to the
controls.
The sounds are deactiva‐
ted.
Child Safety Device or
Lock operates.
hob.
The electrical connection is
incorrect.
Remedy
Reduce the heat setting of
the other cooking zones
connected to the same
phase.
Refer to "Power manage‐
ment".
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Remove the object from
the control panel.
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer
to "Daily use".
Refer to "Daily use".
Deactivate the hob and ac‐
tivate it again after 30 sec‐
onds. If comes on
again, disconnect the hob
from the electrical supply.
After 30 seconds, connect
the hob again. If the prob‐
lem continues, speak to an
Authorised Service Centre.
Disconnect the hob from
the electrical supply. Ask a
qualified electrician to
check the installation.