First Data FD130 Quick Setup Manual page 12

FCC REQUIREMENTS
This equipment complies with Part 68 of the
FCC rules and the requirements adopted
by the ACTA. On the base unit of this
equipment is a label that contains, among
other information, the FCC Registration
Number and Ringer Equivalence Number
(REN) for this equipment. IF REQUESTED,
THIS INFORMATION MUST BE GIVEN TO
THE TELEPHONE COMPANY.
The REN is used to determine the number of
devices that may be connected to a telephone
line. Excessive RENs on a telephone line may
result in the devices not ringing in response to
an incoming call. In most but not all areas, the
sum of RENs should not exceed five (5.0). To be
certain of the number of devices that may
be connected to a line, as determined by
the total RENs, contact the local telephone
company. For products approved after July
23, 2001, the REN for this product is part
of the product identifier that has the
format US: N7KMM09BT110P. The digits
represented by 09B are the REN without a
decimal point (e.g., 03 is a REN of 0.3). For
earlier products, the REN is separately shown
on the label. If your equipment causes harm to
the telephone network, the telephone company
may discontinue your service. If you experience
trouble with this telephone equipment, please
contact the following address and phone
number for information on obtaining service
or repairs. The telephone company may ask
that you disconnect this equipment from the
network until the problem has been corrected
or until you are sure that the equipment is not
malfunctioning. This equipment may not be
used on coin service provided by the telephone
company. Connection to party lines is subject
to state tariffs.
TASQ Technology
1169 Canton Road, Marietta, GA 30066
(800) 827-8297 A plug and jack used to
connect this equipment to the premises wiring
and telephone network must comply with the
applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant telephone
cord and modular plug is provided with this
product. It is designed to be connected to a
compatible modular jack that is also compliant.
See installation instructions for details.
NOTICE: The Ringer Equivalence Number
(REN) for this terminal equipment is 09B.
The REN assigned to each terminal equipment
provides an indication of the maximum number
of terminals allowed to be connected to a
telephone interface. The termination on an
interface may consist of any combination of
devices subject only to the requirement that
the sum of the Ringer Equivalence Numbers of
all the devices does not exceed five.
© 2013 First Data Corporation. All Rights Reserved. All trademarks, service marks and trade
names referenced in this material are the property of their respective owners.
MIS-FD130-SUGDE
AVIS: L'indice d'équivalence de la sonnerie
(IES) du présent matériel est de 09B.
L'IES assigné à chaque dispositif terminal
indique le nombre maximal de terminaux
qui peuvent êtreraccordés à une interface
téléphonique. La terminaison d'une interface
peut consister en une combinaison quelconque
de dispositifs, à la seule condition que la somme
d'indices d'équivalence de la sonnerie de tous
les dispositifs n'excède pas 5.
FCC STATEMENT
This Equipment has been tested and found
to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential
area is likely to cause harmful interference in
which case the user will be required to correct
the interference at his own expense.
4428 0413