Table Of Contents - Dantherm HCV 4 Installation Manual

Overview
Introduction This is the installation and service manual for the HCV 4 and HCV 5v12 domestic venti-
lation units from Dantherm Air Handling.
The table of contents below lists the sections in this manual.
Serial number This guide covers units with serial numbers higher than: 1201091250905
The duct system must not be installed until the unit is ready for use. The power must
Warning
not be connected until the duct system has been installed.
The ventilation unit should not be used to dry newly built houses, during construction
or immediately after construction.
The unit should only be installed at ambient temperatures of 10° or higher.
The ducts must be covered, and the unit must not be connected until the house is ready
for occupation, which means that the house is clean and dry. This is to prevent building
dust and condensation from settling in the duct system and to prevent hygiene prob-
lems in the ventilation unit at a later date.
If the above is not complied with, the warranty on the unit will lapse and any type of
service will be carried out at the customer's expense.
Content The manual covers the following sections:
Introduction ................................................................................................................ 1
Assembly and installation ........................................................................................... 5
Service ...................................................................................................................... 14
Introduction
Overview .............................................................................................................. 1
General information ............................................................................................. 2
Product description .............................................................................................. 3
Assembly ............................................................................................................. 5
Adjustment .......................................................................................................... 9
Set points and control strategies ........................................................................ 13
Preventive maintenance ...................................................................................... 14
Spare parts list HCV 4 ........................................................................................ 17
Spare parts list, HCV 5v12 .................................................................................. 19
Troubleshooting guide ....................................................................................... 21
Service agreement .............................................................................................. 26
Technical data ................................................................................................... 27
Dimensions, HCV 4 ............................................................................................ 29
Dimensions, HCV 5v12 ....................................................................................... 30
Electrical diagram .............................................................................................. 31
Index ................................................................................................................. 32
1