Table of Contents
Advertisement
DL-3H1U-WP-W Owners Manual
Quick Start
1.
Connect HDBaseT Link
2.
Connect A/V sources
3.
Connect USB peripherals
4.
Connect display
5.
Connect audio (optional)
6.
Connect and configure control (optional)
7.
Apply power
Connect HDBaseT Link
HDBaseT Connection
Connect a category cable from the DL-3H1U-WP-W HDBaseT output to the DL-HD2-RX or DL-HD2A-RX receivers
HDBaseT input (sold seperately).
Twisted Pair Wiring
Use TIA/EIA-568B wiring for Category 6
connection between the transmitter and
receiver
To ensure proper performance of the DL-3H1U-WP-W it is recommended that you use solid
core shielded Category 6 F/UTP cabling at a minimum. Category 5e F/UTP may perform well
but may not support power over HDBaseT reliably.
For optimized performance use the following Liberty Wire and Cable branded cabling;
Category 6 plenum; 24-4P-P-L6SH
Category 6A plenum; 24-4P-P-L6ASH
Category 6 NON-plenum; 24-4P-L6SH
Category 6A NON -plenum; 24-4P-L6ASH
8
Installation Instructions
When using shielded category cabling ALWAYS...
....use shielded connectors
....properly ground the category cable
1
8
TIA/EIA-568B
Pin 1
Orange/White
Pin 2
Orange
Pin 3
Green/White
Pin 4
Blue
Pin 5
Blue/White
Pin 6
Green
Pin 7
Brown/White
Pin 8
Brown
Advertisement
Table of Contents
