Setting All Mixer Parameters To Default Values; Adjusting The Fader Sensitivity; Setting Input Levels - Tascam FW-1082 Owner's Manual

Setting all monitor mix levels to 0 dB
(unity gain)
Press and hold the
then press the
F4 / MAST 0dB
Setting all mixer parameters to default
values
Press and hold the
the key.
F3

Setting Input levels

As previously stated, the
MON MIX
useful for recording live tracks into a DAW applica-
tion. Here's a typical scenario for recording and over-
dubbing using mode:
MON MIX
• Connect your analog and/or digital source(s) to the
FW-1082's inputs.
• In control mode, arm your DAW tracks
COMPUTER
for recording and meter the input level to those
tracks using the DAW's level meters.
• Select to access the monitor mixer con-
MON MIX
trol surface mode.
4 – Control Surface Modes and Operation
key and
SHIFT
key.
key and then press
SHIFT
mode can be very

Adjusting the fader sensitivity

the touch sensitivity of all faders.
• Press and hold the SHIFT
tivity with the
EQ GAIN
• The and indicators are used to show the
REC SEL
level of sensitivity (further to the left indicating less
sensitivity, and further right indicating more
sensitivity).
• Press the key to monitor the inputs
F2 INPUTS
without hearing your existing DAW tracks.
• Solo an input channel by pressing that channel's
SOLO key.
• Adjust the channel's
TRIM
input) or the digital source (if it is a digital input)
until the input meter in your DAW shows a level
that is hot, but not clipping.
• Repeat this procedure for all active input channels.
Once you're done setting up levels, you can return to
control mode and begin recording.
COMPUTER
TASCAM FW-1082 Owner's Manual
This adjusts
key and adjust the sensi-
encoder.
pot (if it is an analog
25