Table of Contents
Advertisement
5 – Using the US-322/366 Mixer Panel
Resetting settings to their default values
If you want to reset all the current settings to their original
values, You can restore the mixer and effect settings to their
factory defaults.
Resetting the mixer
8
Follow these procedures to reset the mixer and output channel
settings.
1. Click "File (F)" in the toolbar on a Windows PC or click
"TASCAM US-322 US-366 Mixer Panel" in the menu bar on a
Mac to open a pulldown menu.
2. Click "Mixer Reset... " in the pulldown menu.
3. When a warning appears as shown below, click "OK".
CAUTION
After resetting, you cannot restore the previous settings.
Before clicking "OK", confirm that you want to reset the
settings.
NOTE
Click "Cancel" to return to the Mixer Panel without resetting.
The mixer and other settings are reset to their default values.
The items reset and their default values are as follows.
"MIXER" page items
i Dynamics effect: Off
i Dynamics effect assignment: Off
i Send effect signal position setting (all channels): POST
i Send level (all channels): 0 (–inf )
i Solo (all channels): Off
i Mute (all channels): Off
i Pan slider (all channels): Center
i Fader (all channels): 0 dB
i Link (all channel pairs): Off
i Send effect: REVERB ON
i Send/return levels: 0 (–inf )
"INTERFACE" page items
US-322
MULTITRACK mode
i LINE OUTPUTS 1-2: mixer output L-R
STEREO MIX mode
i LINE OUTPUTS 1-2: mixer output L-R
US-366
MULTITRACK mode
i LINE OUTPUTS 1-2: mixer output L-R
i DIGITAL OUTPUTS: computer 1-2
i LINE OUTPUTS 3-4: computer 3-4
STEREO MIX mode
i LINE OUTPUTS 1-2: mixer output L-R
i DIGITAL OUTPUTS: mixer output L-R
24
TASCAM US-322/366
i LINE OUTPUTS 3-4: computer 1-2
Resetting the effects
8
Follow these procedures to reset all the effects, including the
one currently shown, to their default values.
1. Click "File (F)" in the toolbar on a Windows PC or click
"TASCAM US-322 US-366 Mixer Panel" in the menu bar on a
Mac to open a pulldown menu.
2. Click "Effect Reset... " in the pulldown menu.
3. When a warning appears as shown below, click "OK".
CAUTION
After resetting, you cannot restore the previous settings.
Before clicking "OK", confirm that you want to reset the
settings.
NOTE
Click "Cancel" to return to the Mixer Panel without resetting.
The effect settings are reset to their default values.
The items reset are as follows.
COMPRESSOR
THRESHOLD, RATIO, ATTACK, RELEASE, GAIN
NOISE SUPPRESSOR
THRESHOLD, SUPPRESSION, ATTACK, RELEASE
DE-ESSER
FREQUENCY, DEPTH
EXCITER
FREQUENCY, DEPTH
EQ
GAIN and FREQ for all bands (LOW, MID, HIGH) and MID
band Q
REVERB
ROOM TYPE, PRE DELAY, REVERB TIME
NOTE
This does not change the effect on/off status or the
assignment of the dynamics effect. These items are restored
to their defaults by resetting the mixer.
See the "Effect explanations" for the default settings of each
effect.
Advertisement
Table of Contents
