Installer 3 Menu; Factory Settings; Setting Maximum Dcp Volt - AERMEC MODUCONTROL Usage Manual

To access the INSTALLER_2 menu, follow the same procedure described for the INSTALLER menu; the only difference
is the value of the password, which is 84.
WARNING The following parameters
must only be modifi ed by qualifi ed
personnel authorised to install the
unit.
PASSWORD = 084
Setting operational parameters (installer level)
MIN
Index - String
value
, , ,
MIN
Index - String
value
2.0V
64
EN
IMDCFJ. 12.05 6343841_03

INSTALLER 3 menu

Fig.9b
MAX
value
0 999

factory settings

Setting maximum DCP Volt

MAX
value
This parameter allows you to set the maximum speed of the fans in the CL units, the greater
the value of this parameter, the higher the pressure available at fan; for an accurate setting
9.9V
of this parameter, please consult the table "Setting maximum DCP Volt "the manual installa-
tion of the units CL
Factory settings
Parameter function
Parameter function
Fig.10b