Advertisement
Assembly
1)
Remove the components from the carton. On the
RH. side of the spreader as shown, remove the
two nuts and lock washers holding the hopper onto the
frame. Install the mounting plate to the frame and
reinstall nuts and lock washers previously removed but
do not tighten. Insert the #10-24 x 1 1/2" screw into the
hole in the front of the mounting plate and frame. Secure
with a locknut supplied. Tighten all the
Install the deflector plate spring into the hole in the
2)
deflector plate. Attach the deflector plate to the
mounting bracket as shown using (2) 1/4-20 x 5/8"
hex bolts and locknuts. TIGHTEN NUTS THEN
LOOSEN NUTS JUST ENOUGH TO ALLOW THE
DEFLECTOR TO SWING FREELY. Attach the kick
plate to the deflector using (2) #10-24 x 1/2" bolts and
locknuts.
Spring
Kick Plate
#10-24 x 1/2"
Screw & Locknut
On the back of the spreader, remove the (2)
3)
plastic plugs and install the spring bracket
onto the hopper as shown using (2) #10-24 x 1/2"
screws and locknuts. Using pliers, attach the spring to
the spring bracket. *If holes are not drilled in the
hopper, use the drill guide on the last page for
correct placement.
#10-24 x 1 1/2
Screw & Locknut
Mounting Plate
1/4-20 x 5/8 Bolt
& Locknut
Deflector Plate
#10-24 x 1/2"
Screw & Locknut
Spring
Spring Bracket
4)
Attach the auxiliary shutoff bracket to the right
side of the upper handle using (2) #10 x 1/1/2"
Philips screws and locknuts. Apply the shutoff label
to handle positioned as shown. "CLOSED" should
be toward hopper.
Aux. Shutoff
Bracket
#10-24 x 1 1/2
Screw & Locknut
5)
Insert the hooked end of the push/pull cable into
the hole in the auxiliary shut off plate. Slide the
auxiliary shutoff plate under the LH. side of the shutoff
plate and between the guide as shown. Auxiliary
shutoff plate should slide freely after installation.
Shutoff Plate
Guide
Aux. Shutoff Plate
6)
Slide the cable clamp onto the cable positioned as
shown. Secure with a #10-24 x 3/8" screw but do
not tighten. Push the Cable Knob in and position the
cable in the clamp so the hopper hole is completely
closed. Tighten screw.
#10-24 x 3/8"
Screw
7)
Slide Push/Pull Cable into notch on bracket
between the washer and hex nut. Tighten nuts
taking care not to twist the cable. Secure cable to
the leg with the wire tie.
Push/Pull Cable
Position
"CLOSED" toward
hopper
Hooked End of
Push/Pull Cable
Cable Clamp
Hopper Hole
Completely Closed
Advertisement
