Installation Procedure - Samsung AM NN4 EH Series User Manual

Installation Procedure

Step 1 Installing the indoor unit
When deciding on the location of the air conditioner the
following restrictions must be taken into account.
1 Place the pattern sheet on the ceiling at the spot
where you want to install the indoor unit.
NOTE
• Since the diagram is made of paper, it may shrink
or stretch slightly due to temperature or humidity.
For this reason, before drilling the holes, be sure
to maintain the correct dimensions between the
markings.
2 Insert bolt anchors, use existing ceiling supports or
construct a suitable support as shown in figure.
Hole in anchor
Hole in plug
3 Install the suspension bolts, depending on the ceiling
type.
20
English
Concrete
Insert
Ceiling support
CAUTION
• Make sure that the ceiling is strong enough to support
the weight of the indoor unit. Before hanging the unit,
test the strength of each attached suspension bolt.
• If the length of the suspension bolt is more than 1.5 m,
4 Screw eight pairs of nuts and washers to the
suspension bolts, making space for hanging the indoor
unit.
CAUTION
• You must install all of the suspension rods.
•
ceiling to allow access for maintenance or repairs to
the drainage pipe connection, the refrigerant pipe
5 Hang the indoor unit to the suspension bolts between
two nuts. Cut a pad stopper and place it on the
stopper and screw the nuts to fix the unit.
6
• A tilt of the indoor unit may cause malfunction of a
built-in float switch and water leaks.
Level