4-2
Identifying and Checking the Delivered Components
4.3
Component Designation
Each drive component is identified by a type designation.
A type plate is attached to all units, including the motor.
A label (cable marker) is wrapped round the ready-made cable. The type
designation and length are indicated on this label. (The designation for the
cable itself, without connector, is printed on the cable sheath.)
The identification of accessories packed in bags is either printed on the
bag or indicated in an accompanying note.
Type Plates on the Drive Controller
1: Power section type plate
2: Control section type plate
Fig. 4-2: Type plate arrangement
Rexroth IndraDrive M
1
2
lt_rt_typenschilderf2.fh7
DOK-INDRV*-HMS+HMD****-PR01-EN-P