Dmx Mode - Beamz Multi Acis III LED Instruction Manual

B. SOUND ACTIVE OR AUTO MODE
Set the product in one of the standalone modes to control without connecting a DMX controller.
Note: Never connect a product that is operating in any standalone mode (auto or sound) to a DMX string connected to a
DMX controller.
Auto mode:
Follow below actions to setup the auto standalone mode:
Press <MENU> repeatedly until Ax x shows on the display.
Use <MENU> select auto program (A1 x – A7 x)
Use <UP> or <DOWN> to choose the speed of the program (Ax 1 – Ax 9).
Press <ENTER>
Mode Program
A1 Mode Auto Program 1
A2 Mode Auto Program 2 (No flash)
A3 Mode Auto Program 3 (Flash)
A4 Mode Auto Program 4 (Effect LED)
A5 Mode Auto Program 5 (Laser)
A6 Mode Auto Program 6 (Strobe LED)
A7 Mode Auto Program 7 (Effect LED+ Laser)
Sound mode:
Follow below actions to setup the sound standalone mode:
Press <MENU> repeatedly until Sx x shows on the display.
Use <MENU> select sound program (S1 x – S7 x)
Use <UP> or <DOWN> to choose the speed of the program (Sx 1 – Sx 9).
Press <ENTER>
Mode Program
S1 Mode Sound Program 1
S2 Mode Sound Program 2 (No flash)
S3 Mode Sound Program 3 (Flash)
S4 Mode Sound Program 4 (Effect LED)
S5 Mode Sound Program 5 (Laser)
S6 Mode Sound Program 6 (Strobe LED)
S7 Mode Sound Program 7 (Effect LED+ Laser)
C. DMX MODE
When selecting a starting DMX address, always consider the number of DMX channels. If you choose a starting address
that is too high, you could restrict the access to some of the product's channels. With 8-channel DMX mode, it defines the
highest configurable address 504.
Press <MENU> repeatedly until dxxx shows on the display.
Use <UP> or <DOWN> to select the starting address (d001 – d512).
Press <ENTER>
Variable Speed
Speed 1~9
Speed 1~9
Speed 1~9
Speed 1~9
Speed 1~9
Speed 1~9
Speed 1~9
Variable Speed
Speed 1~9
Speed 1~9
Speed 1~9
Speed 1~9
Speed 1~9
Speed 1~9
Speed 1~9