Synchronize Remote Sensors With The Base Station - ThermoPro TP-60S Instruction Manual

Note:
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc), or rechargeable (nickel
cadmium) batteries.
EN
For maximum performance in normal conditions we recommend using
good quality alkaline batteries.
If the battery power is low, there will be low battery icon showing
on the base station display.

Synchronize Remote Sensors with The Base Station

Please note: each time the batteries (either base station or remote
sensor) are replaced or base station/remote sensor lost connection,
make sure to follow the below synchronization process to pair and
re-connect the base station and remote senor:
1. Position the remote sensor near the base station;
2. Once the batteries are installed in the base station, the RF signal
icon . (located on the upper left of the base station display) will flash
for 3 minutes, indicating that the base station is in synchronization
mode: it is waiting for remote sensors to be registered.
3. If 3 minutes have passed after the batteries were installed in the
-11-
base station and the RF signal Icon is
and hold the CHANNEL/SYNC button on the back of the base station
for 3-4 seconds until the RF signal icon is flashing again to set it
back in synchronization mode;
4. Install the batteries in the remote sensor and wait for a moment or
just press either the TX or RESET button inside the remote sensor
battery compartment, the remote sensor temperature/humidity will
show on the base station display which indicates the synchronization
is complete.
5. If you have additional remote sensors, repeat the above
register the remote sensors (up to 3 remote sensors can be
registered with one base station);
6. If you have registered more than one sensor, press the CHANNEL/
SYNC button on the base station to select the remote channel you
want displayed permanently on the base station. Press CHANNEL/
SYNC button until you observe a circular arrow on the base station
LCD display under the channel number. The unit will then auto-
scroll, changing from channel to channel every 5 seconds.
NOTE : If you have additional remote sensors, when you are
synchronizing remote sensors with the base station, the unit will
no longer flashing, press
steps to
-12-
EN