Advertisement
③
Take off the heater after unscrewing the fixing bolt by 4~5mm-wrench.
(Install new upper knife and assemble it again vice versa.)
④
If necessary to exchange the lower knife plate, unscrew bolts of the front feeding motor.
⑤
Unscrew bolts of the front feeding roller and take off the motor & the roller.
⑥
Take off the cap by unscrewing bolts.
⑦
Unscrew 3 fixing bolts by 7mm-spanner and take off the lower knife plate.
⑧
If no cutting or one sided cutting, make the upper knife contacted to the lower knife plate
and check the level between upper knife & lower knife plate and power off & adjust gap
or pressure by 7mm-spanner. (Clockwise turn of spanner makes the lower knife plate up,
anti-clockwise turn makes it down.)
E-mail : taewoo@cutex.kr
- 8 -
http://www.cutex.kr
Advertisement
