Set function.(Sensor cutting : "1", Normal cutting : "0")
☞
Sensor cutting
☞
Normal cutting
Running of knife-front roller
Turn on MOTOR SW to prevent cut materials from clinging to the knife blade.
Locate the cutting line of label on the lower knife blade.
(This step must go ahead of sensor adjustment.)
Sensor Adjustment
Light sensor-beam on sensing point of label.
(Refer to "How to use sensor" of next page.)
Press START button.
☞
START
Troubles in cutting,
- Check if you adjust sensor after locating cutting line of label on the knife blade.
- Move the sensor forwards or backwards.
- Check sensitivity & height of the sensor.
E-mail : taewoo@cutex.kr
1
⇒
EXTRA
F I E
:
0
⇒
F I E
LENGTH
CLEAR
:
⇒
S E T
⇒
S E T
- 2 -
http://www.cutex.kr