Advertisement
After changing a part or parts (temp. sensor or heater or temp. controller), you can experience
that there are much temperature-deviation between set temperature(SV) and present
temperature(PV).
In this case, by auto-tuning, you can reduce temperature-deviation between SV and PV.
Please do follow steps for auto-tuning.
- Referring manual, please set your common temperature. (ex, 300
- After PV's reaching set temperature, press "
(referring to below image(left))
If so, with AT lamp blinks, auto-tuning begins.
- After finishing auto-tuning, AT lamp will turn off.
- While auto-tuning, if you want to stop auto-tuning, plesae press "
simultaneously. If so, AT lamp turns off and auto-tuning stops.
- If you change SV (set temperature) during auto-tuning, auto-tuning stops and
temp. controller will use previous parameter.
E-mail : taewoo@cutex.kr
HOW TO DO AUTO-TUNING
- 22 -
℃
)
" and "
" simultaneously.
" and "
"
http://www.cutex.kr
Advertisement
