CONTENTS | SPECIAL INFORMATION SPECIAL INFORMATION SPECIAL INFORMATION OPERATION General information ��������������������������������������� 13 Safety instructions ���������������������������������������������� 13 - Keep children under the age of 3 away from Other symbols in this documentation ���������������������� 13 the appliance if constant supervision cannot be Information on the appliance ��������������������������������...
OPERATION General information Other symbols in this documentation - The power cable may only be replaced (for exam- ple if damaged) by a qualified contractor author- Note ised by the manufacturer, using an original spare General information is identified by the adjacent symbol. part.
OPERATION Appliance description General safety instructions Never cover the appliance Even covering up a section, for example with a towel, WARNING Injury can cause overheating and damage the heating element. - Keep children under the age of 3 away from the - Never cover the appliance. appliance if constant supervision cannot be guar- - Never stick anything onto the appliance (e.g. decora- anteed.
OPERATION Settings Toughened safety glass plate f Switch the appliance on or off using the ON/OFF switch. After reaching the operating temperature, the appliance heats Material losses constantly at around 100 °C. Never operate the appliance when the toughened safety You can operate the appliance with an optional wall mounted glass is damaged.
INSTALLATION Safety INSTALLATION Installation Installation site Safety Material losses Observe the minimum clearances (see chapter "Specifi- Only a qualified contractor should carry out installation, commis- cation / Minimum clearances"). sioning, maintenance and repair of the appliance. Material losses General safety instructions The appliance is not suitable for mounting on ceilings or inclines.
Page 7
INSTALLATION Installation 9.2.2 Retaining bracket 9.2.4 Fitting the retaining bracket The appliance is supplied with a retaining bracket to prevent the wall mounted appliance from moving or tilting. Two mounting holes for the retaining bracket are already pre- punched into the rear panel. These mounting holes are each pro- vided with a fixing screw for the retaining bracket.
INSTALLATION Handover Power supply 11. Maintenance The appliance contains no serviceable parts. WARNING Electrocution Carry out all electrical connection and installation work 12. Specification in accordance with relevant regulations. Material losses 12.1 Dimensions and connections The specified voltage must match the mains voltage. f Observe the type plate.