First Use; Switching On The Scales / Measuring Weight - Silvercrest SPWD 180 H1 Operating Instructions And Safety Instructions


You can then successively enter gender [male (23)/female (24)], age (26), height and level
of activity via the
You can use the level of activity to specify your sporting activity. 5 levels of
activity are available: AC-1 = none, AC-2 = little, AC-3 = normal, AC-4 =
moderate and AC-5 = intense.

8. First use

A solid surface is required to measure weight correctly. Thus always place the
diagnostic scales on a solid, horizontal floor covering and never on carpet.
This can distort the measurement result.
To obtain comparable measurement results, you should always weigh yourself
if possible at the same time of day (preferably in the morning). Always weigh
yourself if possible under the same conditions: on an empty stomach, after
having gone to the toilet and naked.
Please note that values for the stone unit of weight are not represented as
decimal values. The display is divided into two segments by a colon. Only
whole numbers are displayed in the "st" unit of weight to the left of the colon.
The remaining weight is displayed in the "lb" unit of weight to the right of the
colon.
Example: "6:8.2 st:lb" is shown on the display. This corresponds to 6st and
8.2 lb.
The diagnostic scales must be calibrated before first use or after having been
moved to ensure that they can determine one's weight exactly. To do so, step
briefly on to the tread (5), step off it again and wait until the diagnostic scales
switch off automatically. The diagnostic scales are now calibrated.

8.1 Switching on the scales / measuring weight

Due to the step on power function, the diagnostic scales are switched on automatically when you
step on the tread (5) and they start to measure your weight immediately.
In their original state, the diagnostic scales are set to the "kg" (13) unit of weight. Once the selected
unit of weight is displayed, press the buttons
weight is then indicated on the LCD display (1).
Stand on the tread (5) of the diagnostic scales so that your weight is evenly distributed. Remain as
still as possible during the weighing process as the measurement result may be distorted otherwise.
The measurement result is indicated on the LCD display (1) during the weighing process. The
measurement is complete when the display flashes.
▲ ▼
button (2) and button (4). Confirm each entry using the SET button (3).
▲ ▼
(2) or (4) to change it. The selected unit of
SilverCrest SPWD 180 H1
English - 9