VESTEL ED24V78/D User Manual page 16

Signage Menu Contents
Device Info
Set ID
Software version
Serial number
Model name
Save model
information
Display Life Time
Controls
No Signal
No Signal Delay
No signal Power
off
Panel Lock
Power Up Settings
Power Up Mode
Quick Standy
Power on Delay
Auto Launch
Boot Up Picture
Mode
HDMI1 Wake Up
Sets the device ID. You can select a value between 0-99 using the numeric buttons
on the remote in order to identify your Display.
Displays current software version.
Displays serial number of the unit. (Cannot changed by user)
Displays model name of the unit. (Cannot changed by user)
Copies the model information data of the unit to a connected USB device.
Displays the duration of life of the unit.
Sets the behavior preference of the Display, when no signal is detected from the currently
set input source. Failover and Input Search options are available.
If Failover is selected the Display checks the connected USB device for available
files to play. If no playable files are available or there is no USB device connected to
the Display, the No Signal image will be displayed. If there isn't any No Signal Image
available, No Signal OSD will be displayed on the screen. The setting of the USB Auto
Play option in the Settings>System>More menu is not important, in Failover mode it
will function anyway.
If Input Search is selected the Display will search all available input sources consecutively
to find signal. If no signal is detected from other available sources, No Signal OSD will
be displayed and the Display will turn itself off after a period of 30 seconds.
Sets a delay value to the 'No Signal' preferences when the Display is in No Signal state.
After the set delay time is expired 'No Signal' preferences will be applied.
When enabled the Display will turn itself off after a period of 5 minutes, if no signal is
received from the selected source.
This feature will only work if all of the following circumstances occur:
- No Signal option is set as Failover.
- USB device is not connected to the Display / USB device is connected but there are
no playable files installed on the USB device.
Set as Off to prohibit the use of the buttons on the Display.
Configures the power up mode preference. Last State, Always On and Standby
options are available.
If this feature is enabled the Display can be turned on again with the RS232 and LAN
commands if it is turned off through it. Press Left or Right button to enable or disable
the feature.
Sets a delay value at power on. This value can be set from 0 to 2000 ms in steps of 100
ms. The Display will turn on after the set delay time is expired.
Configures the auto launch preference. CMS(Start url), Open Browser(Open Browser
initial page) and Disabled options are available.
Configures the picture mode preference at power on. If set as Off the last set picture
mode will be used at power on.
If this option is set as Enabled, the Display will turn on with the HDMI input source,
when it is switched on. This feature works based on HDMI 5V signal. When this signal
is active the Display wakes up and when the signal is inactive the Display shuts down.
You can disable this option by setting as Disabled.
If any Scheduler is set or an OPS unit is connected to the Display, this option will be
inactive and can not be set as Enabled.
Note: This feature may not be available depending on the model of your unit.
English - 14 -