TANDBERG N3 User Manual page 45

Configuration commands
xConfiguration SubZones
TraversalSubZone Bandwidth Total Mode:
<None/Limited/Unlimited>
xConfiguration SubZones SubZone
[1..100] Bandwidth PerCall Limit:
<1..100000000>
xConfiguration SubZones SubZone
[1..100] Bandwidth PerCall Mode:
<None/Limited/Unlimited>
xConfiguration SubZones SubZone
[1..100] Bandwidth Total Limit:
<1..100000000>
xConfiguration SubZones SubZone
[1..100] Bandwidth Total Mode:
<None/Limited/Unlimited>
xConfiguration SubZones SubZone
[1..100] Name: <subzonename>
xConfiguration SubZones SubZone
[1..100] Subnet IP Address: <IPAddr>
xConfiguration SubZones SubZone
[1..100] Subnet IP Mask: <IPAddr>
xConfiguration SystemUnit Name: <name>
xConfiguration SystemUnit Password:
<password>
xConfiguration Telnet Mode: <On/Off>
xConfiguration Traversal
AllowMediaDirect: <On/Off>
xConfiguration Traversal Server
Address: <IPAddr>
xConfiguration Traversal Registration
RetryInterval: <seconds>
xConfiguration Zones DefaultZone
Gatekeeper HopCount: <1..255>
xConfiguration Zones TraversalZone
Gatekeeper HopCount: <1..255>
xConfiguration Zones Zone [1..100]
Gatekeeper IP Address: <IPAddr>
Description
Whether or not the traversal subzone is enforcing total
bandwidth restrictions. None corresponds to no bandwidth
available.
Per-call bandwidth available on the indexed subzone.
Whether or not the indexed subzone is enforcing per-call
bandwidth restrictions. None corresponds to no bandwidth
available.
Total bandwidth available on the indexed subzone.
Whether or not the indexed subzone is enforcing total
bandwidth restrictions. None corresponds to no bandwidth
available.
Name of the indexed subzone.
IP to match an endpoint which belongs in this subzone.
Subnet mask to match endpoints which belong in this subzone.
The name of the unit. Choose a name that uniquely identifies
the system.
Specify the password of the unit. The password is used to login
with Telnet, HTTP(S), SSH, SCP, and on the serial port.
To set an empty password type
xConfiguration SystemUnit Password: ""
Enables/disables Telnet support.
You must restart the system for changes to take effect.
Determines whether or not capable endpoints may send their
media directly to the Border Controller, bypassing the
Gatekeeper.
The defaults is Off.
IP address of the Border Controller that this Gatekeeper should
connect to.
Frequency with which failed registrations with the Border
Controller should be repeated.
The default is 120 seconds.
Maximum hop count to use when issuing LRQs to Gatekeepers
in this zone.
The default is 15 hops.
Maximum hop count to use when issuing LRQs to Gatekeepers
in this zone.
The default is 15 hops.
Specifes the IP address of neighbor gatekeeper.
39