Command - TANDBERG N3 User Manual

TANDBERG Gatekeeper User Manual
Configuration commands
xConfiguration Zones Zone [1..100]
Gatekeeper IP Port: <1..65534>
xConfiguration Zones Zone [1..100]
Gatekeeper HopCount: <1..255>
xConfiguration Zones Zone [1..100]
Name: <zonename>
xConfiguration Zones Zone [1..100]
Prefix Match: <prefix>
xConfiguration Zones Zone [1..100]
Prefix Mode: <Strip/Include>

5.3 Command

The command root command, xcommand, is used to execute commands on the Gatekeeper.
To list all xcommands type
xcommand ?
To get usage information for a specific command, type
xcommand <commandname> ?
Command Usage
AllowListAdd
xCommand AllowListAdd
<allowed_alias>
AllowListDelete xCommand AllowListDelete
<index>
Boot xCommand Boot
CheckBandwidth xCommand CheckBandwidth
<node1> <node2> <bandwidth>
<calltype>
CredentialAdd xCommand CredentialAdd:
<username> <password>
CredentialDelete
xCommand CredentialDelete:
<index>
DefaultLinksAdd xCommand DefaultLinksAdd
DefaultValuesSet xCommand DefaultValuesSet
Level: <level>
40
Description
Specifies the IP port of the neighbor gatekeeper
Maximum hop count to use when issuing LRQs to Gatekeepers
in this zone.
The default is 15 hops.
Specifies the name of a zone in the zone list
Prefix to use for the indexed zone.
Whether or not to strip prefixes when forwarding an LRQ to the
indexed zone.
The default is Include.
Description
Adds an entry to the allow list, used by the registration
restriction policy.
Removes the pattern from the allow list at the specified
index.
Restarts (boots) the Gatekeeper.
This takes approximately 1 minute to complete.
Diagnostic function for verifying bandwidth control. Node1,
Node2 are the case sensitive names of the nodes,
bandwidth the required bandwidth and calltype one of
Traversal or NonTraversal.
Adds the given username and password to the local
authentication database.
Deletes the indexed credential.
Restores the factory default links for bandwidth control.
Resets system parameters to default values.
Level 1 will reset most parameters, except networking
related ones. Level 2 and 3 reset progressively more
parameters.