Remote Control - Inserting Batteries; Remote Control - Using Tips; Basic Functions; Switching The Appliance On And Off - Telefunken MC1004M Instruction Manual

Note: The appliance draws a small amount of power even if it is not turned on. If you do not
■
use the appliance for a longer period of time, disconnect the power plug to completely switch
off the appliance.
3.5 Remote control – inserting batteries
For operation of the remote control 1 x 1.5 V
■
battery (type AAA / LR03 / R03) is needed (not
supplied).
Lift up and remove the battery compartment cover.
■
Insert the battery according to the polarity
■
markings inside the battery compartment and on
the battery.
Close the battery compartment cover and make
■
sure it snaps into place.
If the remote control does not work properly,
■
replace the battery.
Use batteries of high quality only. Batteries of low
■
quality might leak and cause damage.
Note: Remove the battery if the remote control
■
is not to be used for a longer period of time, as it
might be damaged by leaking batteries.
3.6 Remote control – using tips
Aim the remote control directly at the appliance.
■
The distance should be less than 7 metres and
within 30°. Make sure there are no obstacles
between the remote control and unit.
The remote control may be less effective if:
■
there are obstacles between the remote control
and the appliance.
other remote controls are operated at the same
time.
the battery is low.
4.

BASIC FUNCTIONS

4.1

Switching the appliance on and off

Connect the power plug to a suitable electrical outlet. The standby power indicator light up in red.
■
Press
■
briefly shows
Press again
■
Note the that appliance is powered as long as it is connected to the electrical outlet.
To completely switch off the appliance, disconnect the power plug from the electrical outlet.
■
Do this if you do not use the appliance for a longer period of time.
4.2

Setting volume

Set the volume with the VOLUME (–/+) volume control.
■
The display shows
■
to . When reaching the end of the volume range, the display shows
to switch on the appliance. The standby power indicator goes out and the display
.
to switch the appliance to standby mode. The display briefly shows
with a current set volume, e.g. . The volume settings range from
22
AAA /
LR03 /
R03
.
or .