How To Use; Getting Started; Auto Clean - Black & Decker Digital Advantage D1200 Use And Care Book Manual

D1600Pub1000003023 6/2/06 10:20 AM
Product may vary slightly from what is illustrated.
1. Spray nozzle
2. Water-fill cover
3. Digital display window
4. Surge-of-steam button
5. Spray button
6. Comfort Grip™ handle
7. 360-degree swivel cord
8. Smart stand/cord wrap

9. AUTO CLEAN

button
®
10. Water window with MAX mark
11. Fabric-select dial
12. Soleplate
3
Page 4
Symbols
Surge-of-Steam
Spray
Dry

How to Use

This appliance is intended for household use only.

GETTING STARTED

Remove any labels, stickers or tags attached to the body or soleplate of the iron.
Note: Use ordinary tap water for ironing. Do not use water processed through a home
softening system
Important: For optimum performance, let the iron stand for 90 seconds before beginning
to iron.
Filling Water Tank
1. Open the water-fill cover as shown in (A).
A
2. Tilt the iron and using a clean measuring cup, pour water into
opening until the water reaches the MAX level mark on the water
tank (B). Do not overfill.
3. Close the water-fill cover.
Note: If you need to add water while ironing, unplug the iron and
follow above steps.
B
4. Plug in the iron. The iron beeps and digital display window
illuminates green.
Selecting Temperature
1. Read garment's label to help you determine fabric type.
Tip: If unsure of a garment's fiber, test a small area (on an inside seam or hem) before
ironing.
2. Once you determine the fabric type, turn fabric-select dial to
appropriate temperature setting (from 1 to 6).
Tip: As a guide, the digital display shows the setting number with
the corresponding recommended fabric type.
3. Once the iron reaches the selected temperature, it beeps and
C
displays READY (C).
3-Way Automatic Shutoff
The automatic shutoff feature in your iron works as follows:
• Once the iron reaches appropriate temperature, it will turn off
30 seconds
after 30 seconds of inactivity if left on its soleplate or tipped over
on its side. If left vertically on its heel rest, it will shut off after 8
minutes (D).
8 minutes
D
• The unit beeps three times and AUTO OFF flashes on the digital
display window to let you know the iron has stopped heating (E).
• After a few minutes, the digital display light goes off.
• If you pick up the iron, it activates an internal motion sensitive
detector and the iron will start heating again. You might have to
E move the iron or shake it gently. The digital display light comes
on and the set temperature is displayed again.
Note: Wait for iron to reheat completely before resuming operation.
4