Advertisement
154574-00/2610-220
5/17/02
1:45 PM
Figure 1
SIDE HANDLE
R
F
Page 3
HOLDING KNOB
SPADE HANDLE
REVERSE
FORWARD
LOCK BUTTON
Figure 2
4. Open chuck jaws fully. Insert screwdriver (or 3/16" hex wrench if
required) into front of chuck between jaws to engage screw head.
5. Remove screw by turning clockwise (left-hand thread).
6. Place key in chuck as shown in Figure 5.
7. Using a wooden mallet or similar object, strike key sharply in a
counterclockwise direction. This will loosen chuck so that it can be
unscrewed by hand (Figure 5).
Drilling
1. Always turn off tool and disconnect from power supply when attaching or
changing bits or accessories.
2. Use sharp drill bits only. For WOOD, use twist drill bits, spade bits, power
auger bits, or hole saws. For METAL, use high speed steel twist drill bits
or hole saws. For MASONRY, such as brick, cement, cinder block, etc.,
use carbide-tipped bits
Figure 3
3
Advertisement
