Related Manuals for Black & Decker 1166-220
Summary of Contents for Black & Decker 1166-220
- Page 1 154569/1166-220 5/17/02 1:39 PM Page 2 Black & Decker (U.S.) Inc. • 701 East Joppa Road, Towson, Maryland 21286 Printed in U.S.A. (FEB96-CD-1) Form No. 154569 Copyright © 1996...
- Page 2 154569/1166-220 5/17/02 1:39 PM Page 3 Instruction Manual 1166-220 3/8" VSR Drill...
- Page 3 Safety Instructions For All Tools • KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries. 1166-220 3/8" VSR Drill • CONSIDER WORK AREA ENVIRONMENT. Don’t expose power tools to rain. Don’t use power tools in damp or wet locations. Keep work area well lit. Do not use tool in presence of flammable liquids or gases.
- Page 4 154569/1166-220 5/17/02 1:39 PM Page 2 shows the correct size to use depending on cord length and nameplate • STORE IDLE TOOLS. When not in use, tools should be stored in dry, and ampere rating. If in doubt, use the next heavier gage. The smaller the gage high or locked-up place —...
-
Page 5: Tool Operation
154569/1166-220 5/17/02 1:39 PM Page 3 TOOL OPERATION the plug from the power supply. Failure to do so will cuase the drill to start immediately the next time it is plugged in. Damage or injury could result. Switch The variable speed trigger switch permits speed control. The farther the trigger switch is depressed, the higher the speed of the drill. -
Page 6: Chuck Removal
154569/1166-220 5/17/02 1:39 PM Page 4 Chuck Removal 6. IF DRILL STALLS, it is usually because it is being overloaded. RELEASE TRIGGER IMMEDIATELY, remove drill bit from work, and determine 1. TURN OFF TOOL AND DISCONNECT FROM POWER SUPPLY. cause of stalling. DO NOT CLICK TRIGGER OFF AND ON IN AN ATTEMPT 2. -
Page 7: Maintenance
154569/1166-220 5/17/02 1:39 PM Page 5 MAINTENANCE Drilling in Metals Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which should be drilled dry. The cutting lubricants that work best Lubrication are sulphurized cutting oil or lard oil; bacon grease will also serve the pur- All ball and sleeve bearings used are factory lubricated to last the life of the pose. - Page 8 154569/1166-220 5/17/02 1:39 PM Page 6 Every B&D tool is of the highest quality. If you wish to contact us regarding this product, please call toll free between 8:00am and 8:00pm ET, seven days a week: 1-800-9-BD TOOL (1-800-923-8665) One Year Service/Safety Check All B&D tools for Industry and Construction are covered under a...