NordicTrack T7.5 S User Manual page 11

9. IMPORTANT: To avoid damaging the Pulse
Crossbar (93), do not use power tools and do
not overtighten the #10 x 3/4" Screws (9).
Attach the Pulse Crossbar (93) to the right hand-
rail assembly (I) and the left handrail assembly
(not shown) with four #10 x 3/4" Screws (9)
and four #10 Star Washers (5) (only one side
is shown); start all of the Screws, and then
tighten them.
10. With the help of a second person, hold the
console assembly (L) near the console base
assembly (G).
Connect the wires (M) from the console base
assembly (G) to the wires (N) from the console
assembly (L). The connectors should slide
together easily and snap into place. If they do
not, turn one connector and try again.
Next, locate the console wire (O) in the con-
sole assembly (L). Connect the Upright Wire
(81) to the console wire.
(M, N) into the hole in the Console Base (64).
Insert the wires (O, 81) into the console assem-
bly (L), and position the wires on the decal.
Then, insert the wires
9
10
N
M
64
11
9
5
93
I
L
O
81
G