Maintenance And Care - Flex L1710FRC Operating Instructions Manual

Operating instructions
2SXI
Rough-grinding
(ERKIV
Never use cutting-off wheels for rough-
grinding.
– Angle of wheel 20–40° for best cutting
performance.
– Applying moderate pressure, move the
angle grinder backwards and forwards.
As a result, the workpiece will not
become too hot and there will be no
discoloration; nor will there be any
grooves.
Cut-off grinding
– Do not press, tilt or oscillate the power
tool.
– The angle grinder must always be
operated backwards, see diagram.
Otherwise, there is a risk of the angle
grinder jumping uncontrollably out of
the groove.
– Adjust the feed to the material which
is to be cut:
the harder the material, the slower
the feed.
20
Angle grinder L1109FE, L1710FRA, L1710FRC
For further information on the manufacturer's
products go to www.flex-tools.com.

Maintenance and care

(ERKIV
Cleaning
(ERKIV
If metals are ground or cut over a prolonged
period, conductive dust may become
deposited inside the housing.
Impairment of the protective insulation!
Operate the power tool via a residual-current-
operated circuit-breaker (tripping current
30 mA).
Regularly clean the power tool and ventilation
slots. Frequency of cleaning is dependent on
the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
Carbon brushes
The angle grinder features cut-off carbon
brushes.
When the wear limit of the cut-off carbon
brushes is reached, the angle grinder
switches off automatically.
2SXI
When the angle grinder is being used, the
carbon brushes can be seen sparking
through the rear air inlet apertures.