Advertisement
6.2.
youR DeViCe at a GlaNCe
1. Tool receiving socket
2. Holder for the depth stop
3. lock button for depth stop
4. Rotation direction switch
5. Function button
6. Locking button
7. Auxiliary handle
6.3.
RemoViNG a tool
6.3.1.
Pull the tool holder back (fig.2.1).
6.3.2.
Remove the tool.
6.4.
iNSeRtiNG a tool
WaRNiNG! Risk of injury! Make sure that when
‰
installing the tool that it fits securely in the clamping
chuck and is not at an angle.
note:
Clean and grease the shaft of the tool before
inserting.
6.4.1.
Pull the tool holder back (fig.2.1).
6.4.2.
Insert the required tool with a slight turn until the
tool holder locks.
fig.2
6.5.
SeleCtiNG tHe oPeRatiNG moDe
WaRNiNG! Risk of damage to the unit! only change operating mode when the device is
‰
switched off (fig.3).
WaRNiNG! Risk of damage to the unit! Do Not use settings [
‰
screwing in and removing screws. Do Not use settings [
note:
The position [
] is only used to rotate the tool to the required position. To chase, the switch
must be set to position [
6.5.1.
Press the lock button and set the switch to the required operating mode (fig.3.6).
6.5.2.
Position [
] for drilling without the hammer function into wood, metal, ceramics and
plastics and for the screwdriver function.
6.5.3.
Position [
] for hammer drilling in cement or stone.
6.5.4.
Position [
] for chasing in cement or stone.
6.6.
CHaNGiNG tHe RotatioN DiReCtioN
WaRNiNG! Risk of damage to the unit! only use the rotation direction switch when the device is at a standstill.
‰
6.6.1.
To drill and screw screws into place, press the rotation direction switch to the left (rotation in clockwise direction).
6.6.2.
To remove screws, press the rotation direction switch to the right (rotation in an anti-clockwise direction).
6.7.
CHeCk befoRe SWitCHiNG oN!
6.7.1.
Check to make sure the unit is in a safe operating condition:
6.7.2.
Check to make sure there are no visible defects.
6.7.3.
Check to make sure all unit components are correctly mounted.
6.8.
SWitCHiNG oN aND off
note:
The revolution speed of the device can be varied by applying different pressures to the On/Off switch.
6.8.1.
To start the tool turning, press the On/Off
6.8.2.
To operate permanently, press the lock- On/Off switch.
6.8.3.
Press the On/Off switch again and release to release the lock.
6.8.4.
To switch the unit off, release the On/Off switch
6.9.
DRilliNG
▲
DaNGeR! Risk of injury! never hold the work piece that you are working with in your hand, on your lap, or against other body parts.
WaRNiNG! Risk of damage to the unit! never use the drill for chasing or to expand drilled holes. Always use a drill appropriate to the
‰
material.
6.9.1.
Hold the device straight and drill with even pressure.
© Jack Sealey limited
fig.1
] (fig.3.5).
Original Language Version
], [
] and [
] for
] and [
] for chasing.
fig.3
SDSPLUS32 Issue 1 27/08/19
Advertisement
